58410B
1.REMOVE DECK BOARD ASSEMBLY
58411A
2.REMOVE NO. 1 DECK BOARD
58412A
3.REMOVE NO. 2 DECK BOARD
64993
4.REMOVE REAR DECK FLOOR BOX
64995
5.REMOVE DECK FLOOR BOX RH
64910J
6.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
67935A
7.REMOVE BACK DOOR SCUFF PLATE
72127D
8.REMOVE SEAT TRACK BRACKET COVER RH
72159H
9.REMOVE REAR SEAT TRACK BRACKET COVER
72128C
10.REMOVE SEAT TRACK BRACKET COVER LH
11.REMOVE REAR NO. 2 SEAT ASSEMBLY
67918A
12.REMOVE REAR DOOR SCUFF PLATE LH
62332A
13.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
64721G
14.REMOVE NO. 1 DECK TRIM COVER
58460D
15.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
64713F
16.REMOVE FRONT DECK SIDE TRIM COVER LH
55548C
17.REMOVE NO. 2 CUP HOLDER
73370C
18.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
73570
19.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Lower Side)
81250
20.REMOVE NO. 2 ROOM LIGHT ASSEMBLY
64740C
21.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
62480A
22.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH
86011R
23.REMOVE RADIO SETTING CONDENSER
When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
Disengage the claw and pull out the cover as shown in the illustration.
Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.