Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › from 2016.05
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301729 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64910J 6.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 72127D 8.REMOVE SEAT TRACK BRACKET COVER RH

Hide 72159H 9.REMOVE REAR SEAT TRACK BRACKET COVER

Hide 72128C 10.REMOVE SEAT TRACK BRACKET COVER LH

Hide 11.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 67918A 12.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332A 13.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 58460D 15.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

Hide 64713F 16.REMOVE FRONT DECK SIDE TRIM COVER LH

Hide 73370C 18.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

Hide 73570 19.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Lower Side)

Hide 64740C 21.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62480A 22.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

Hide 86011R 23.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E223703

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E226094

Disengage the claw and pull out the cover as shown in the illustration.


d.
E232601

Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.


e.
E223708

Using a screwdriver, bend back and break off the claw as shown in the illustration.


f.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the wire harness on the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.