Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Radio Receiver Power Source Circuit  


DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

E351353E06
5.271,3.625 6.948,4.042 1.677,0.417 10 false Radio and Display Receiver Assembly 5.448,3.167 5.906,3.365 0.458,0.198 10 false L36 5.448,1.583 5.906,1.781 0.458,0.198 10 false L36 5.438,0.802 5.896,1 0.458,0.198 10 false L36 5.438,2.375 5.896,2.573 0.458,0.198 10 false L35 5.781,3.177 6.396,3.375 0.615,0.198 10 false GND1 5.823,2.385 6.438,2.583 0.615,0.198 10 false IG 5.802,1.594 6.417,1.792 0.615,0.198 10 false ACC1 5.792,0.792 6.406,0.99 0.615,0.198 10 false +B1 5.521,0.615 5.677,0.813 0.156,0.198 10 false 4 5.521,1.396 5.677,1.594 0.156,0.198 10 false 3 5.521,2.979 5.677,3.177 0.156,0.198 10 false 7 5.51,2.188 5.667,2.385 0.156,0.198 10 false 1 3.219,2.635 4.281,2.833 1.063,0.198 10 false ECU-IG NO. 2 3.365,1.833 4.198,2.031 0.833,0.198 10 false ECU-ACC 3.313,1.042 4.156,1.281 0.844,0.24 10 false RAD NO. 1 0.438,0.781 1.896,1.094 1.458,0.313 10 false from Auxiliary Battery 0.792,1.573 2.625,1.823 1.833,0.25 10 false from ACC Relay 0.5,2.344 1.979,2.552 1.479,0.208 10 false from IG1 NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND)
a.

Disconnect the L35 and L36 radio and display receiver assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L36-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L36-4 (+B1) - L36-7 (GND1) Power switch off 11 to 14 V
L36-3 (ACC1) - L36-7 (GND1) Power switch on (ACC) 11 to 14 V
L35-1 (IG) - L36-7 (GND1) Power switch on (IG) 11 to 14 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR