The radio and display receiver assembly receives a reverse signal from the power management control ECU via the No. 1 integration relay.
Disconnect the L35 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L35-2 (REV) - Body ground | Power switch on (READY)
Reverse (R) selected |
11 to 15.5 V |
| L35-2 (REV) - Body ground | Power switch on (READY)
Reverse (R) not selected |
Below 1 V |
OK
NG
Disconnect the L35 radio and display receiver assembly connector.
Disconnect the 1G No. 1 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L35-2 (REV) - 1G-4 (NAV) | Always | Below 1 Ω |
| L35-2 (REV) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the 1G No. 1 integration relay connector.
Disconnect the A21 power management control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1G-13 (BKUP) - A21-15 (BL) | Always | Below 1 Ω |
| 1G-13 (BKUP) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the No. 1 integration relay with a new or known good one (See page Power Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL).
Check that the malfunction disappears.
Malfunction disappears.
OK
NG