Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted  


CAUTION / NOTICE / HINT

HINT:

If an outlet of the air conditioning system is facing the microphone, noise may be recorded and the other caller may not be able to hear your voice properly.


PROCEDURE

1.CHECK CELLULAR PHONE
a.

Check if the other caller can hear your voice properly.

OK:

Your voice can be heard properly.


HINT:

The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.




OK

2.CHECK SETTINGS

NG

REPLACE CELLULAR PHONE

2.CHECK SETTINGS
a.
E225861E01
0.095,0.08 0.251,0.228 0.156,0.147 10 *a

Display the "Call" screen.


b.

Check that the "Mute" switch is not set to on.

OK:

"Mute" switch is not set to on.


Text in Illustration
*a Example



OK

3.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

NG

TURN "Mute" SWITCH OFF

3.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)
a.
E225853

Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK).


b.

When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

OK:

Check result is normal.




OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE