Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly*1, radio and display receiver assembly or speakers.

*1: for 8 Speakers


WIRING DIAGRAM

E227368E13
1.417,0.554 1.512,0.704 0.096,0.150 10 9 0.922,0.638 1.333,0.788 0.412,0.150 10 AUXO 1.417,1.745 1.512,1.895 0.096,0.150 10 8 0.922,1.829 1.333,1.979 0.412,0.150 10 ASGN 1.417,2.137 1.594,2.287 0.177,0.150 10 10 0.914,2.221 1.333,2.372 0.420,0.150 10 AGND 1.417,0.946 1.512,1.097 0.096,0.150 10 6 1.015,1.031 1.334,1.181 0.319,0.150 10 ARO 1.417,1.348 1.512,1.499 0.096,0.150 10 7 1.036,1.432 1.334,1.583 0.298,0.150 10 ALO 5.611,0.554 5.785,0.704 0.174,0.150 10 25 5.868,0.638 6.280,0.788 0.412,0.150 10 ADPG 5.611,1.745 5.785,1.895 0.174,0.150 10 27 5.868,1.829 6.122,1.979 0.254,0.150 10 VA- 5.611,2.137 5.784,2.287 0.172,0.150 10 11 5.868,2.221 6.288,2.372 0.420,0.150 10 AGND 5.611,0.946 5.785,1.097 0.174,0.150 10 26 5.868,1.031 6.257,1.181 0.389,0.150 10 VAR+ 5.611,1.348 5.785,1.499 0.174,0.150 10 28 5.868,1.432 6.231,1.583 0.363,0.150 10 VAL+ 0.207,2.674 0.539,2.825 0.332,0.150 10 L13 0.207,2.843 1.863,3.170 1.656,0.327 10 No. 1 Stereo Jack Adapter Assembly 5.657,2.674 5.989,2.825 0.332,0.150 10 L35 5.657,2.843 6.869,3.170 1.211,0.327 10 Radio and Display Receiver Assembly 2.477,2.351 3.137,2.501 0.660,0.150 10 (Shielded) 4.062,2.351 4.722,2.501 0.660,0.150 10 (Shielded)

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the L35 radio and display receiver assembly connector.


b.

Disconnect the L13 No. 1 stereo jack adapter assembly connector.


c.
U191335E01
2.117,1.416 2.779,1.172 false 2.828,1.087 3.250,1.233 0.422,0.145 10 AGND 2.218,1.631 2.074,1.963 false 1.814,1.981 2.231,2.126 0.417,0.145 10 VAR+ 2.112,1.631 1.593,1.963 false 1.178,1.981 1.595,2.126 0.417,0.145 10 ADPG 2.45,1.631 2.969,1.963 false 2.889,1.981 3.253,2.126 0.364,0.145 10 VAL+ 2.335,1.631 2.479,1.963 false 2.415,1.981 2.664,2.126 0.248,0.145 10 VA- 0.18,0.169 0.343,0.335 0.163,0.166 10 *a 1.58,0.278 1.829,0.433 0.249,0.156 10 L35 1.583,3.873 1.18,4.232 false 2.529,3.761 2.951,3.907 0.422,0.145 10 AGND 0.924,4.256 1.242,4.401 0.317,0.145 10 ALO 1.87,3.873 2.273,4.232 false 2.157,4.256 2.571,4.401 0.415,0.145 10 AUXO 0.181,2.231 0.382,2.398 0.201,0.166 10 *b 2.049,3.835 2.498,3.835 false 1.403,3.834 0.884,3.834 false 1.73,3.875 1.729,4.417 false 0.46,3.744 0.816,3.890 0.356,0.145 10 ARO 1.485,4.431 1.907,4.577 0.422,0.145 10 ASGN 1.587,2.325 1.836,2.481 0.249,0.156 10 L13

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L35-25 (ADPG) - L13-9 (AUXO) Always Below 1 Ω
L35-11 (AGND) - L13-10 (AGND) Always Below 1 Ω
L35-26 (VAR+) - L13-6 (ARO) Always Below 1 Ω
L35-28 (VAL+) - L13-7 (ALO) Always Below 1 Ω
L35-27 (VA-) - L13-8 (ASGN) Always Below 1 Ω
L35-25 (ADPG) - Body ground Always 10 kΩ or higher
L35-11 (AGND) - Body ground Always 10 kΩ or higher
L35-26 (VAR+) - Body ground Always 10 kΩ or higher
L35-28 (VAL+) - Body ground Always 10 kΩ or higher
L35-27 (VA-) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR