These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15A0 | When either condition below is met:
·
Bus malfunction ·
EEPROM error |
Radio and display receiver assembly |
| B15B0 | Picture circuit (TFT unit) malfunction | |
| B15B3 | When one of the conditions below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
|
| B15B4 | When one of the conditions below is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanism malfunction ·
Mechanical malfunction |
|
| B15B7 | "Bluetooth" module malfunction |
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG