Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B15D3  Stereo Component Amplifier Disconnected  


DESCRIPTION

The radio and display receiver assembly and stereo component amplifier assembly are connected by the AVC-LAN communication line.

When an AVC-LAN communication error occurs between the radio and display receiver assembly and stereo component amplifier assembly, this DTC will be stored.

DTC No. DTC Detection Condition Trouble Area
B15D3 When either condition below is met:
·

Stereo component amplifier assembly is/was not connected while the power switch is/was on (ACC or IG).

·

Communication between the master unit and the stereo component amplifier assembly is/was not possible when the engine is/was started.


·

Stereo component amplifier assembly power source circuit

·

AVC-LAN circuit between radio and display receiver assembly and stereo component amplifier assembly

·

Stereo component amplifier assembly

·

Radio and display receiver assembly

·

Harness or connector



HINT:

The radio and display receiver assembly is the master unit.


WIRING DIAGRAM

E230079E02
0.052,0.629 1.435,0.812 1.383,0.184 10 from Auxiliary Battery 0.323,1.42 1.405,1.608 1.082,0.188 10 from ACC Relay 2.784,1.673 3.435,1.861 0.651,0.188 10 ECU-ACC 3.2,2.219 3.587,2.403 0.386,0.184 10 TX1+ 3.214,2.614 3.563,2.797 0.349,0.184 10 TX1- 5.607,3.015 6.077,3.199 0.470,0.184 10 GND 5.613,2.628 6.000,2.811 0.386,0.184 10 ATX- 5.61,2.233 5.996,2.417 0.386,0.184 10 ATX+ 5.611,1.425 5.998,1.609 0.386,0.184 10 ACC 5.613,0.639 5.999,0.822 0.386,0.184 10 +B 5.343,2.445 5.528,2.629 0.184,0.184 10 7 5.339,2.058 5.434,2.242 0.094,0.184 10 8 5.338,0.459 5.522,0.643 0.184,0.184 10 1 3.605,2.137 3.699,2.320 0.094,0.184 10 7 3.605,2.546 3.699,2.730 0.094,0.184 10 8 2.541,2.976 2.887,3.160 0.346,0.184 10 L35 2.543,3.136 3.756,3.496 1.213,0.360 10 Radio and Display Receiver Assembly 5.431,3.825 6.636,4.141 1.205,0.316 10 Stereo Component Amplifier Assembly 2.966,0.884 3.334,1.072 0.368,0.188 10 AMP 5.345,2.836 5.439,3.020 0.094,0.184 10 3 5.255,3.028 5.530,3.212 0.275,0.184 10 L30 5.607,3.408 6.077,3.591 0.470,0.184 10 GND2 5.295,3.228 5.481,3.430 0.186,0.202 10 18 5.255,3.421 5.530,3.604 0.275,0.184 10 L30 5.262,0.646 5.537,0.830 0.275,0.184 10 L30 5.613,1.031 5.999,1.215 0.386,0.184 10 +B2 5.31,0.852 5.494,1.035 0.184,0.184 10 16 5.262,1.038 5.537,1.222 0.275,0.184 10 L30 5.262,1.435 5.537,1.618 0.275,0.184 10 L31 5.262,2.233 5.537,2.417 0.275,0.184 10 L31 5.255,2.628 5.530,2.811 0.275,0.184 10 L31 5.296,1.233 5.480,1.416 0.184,0.184 10 12

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK DTC
a.

If DTC B15C3 is output, perform the troubleshooting of DTC B15C3 first.

Result:
Result Proceed to
DTC B15C3 is not output A
DTC B15C3 is output B




A

2.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

B

GO TO DTC "B15C3" IN DIAGNOSTIC TROUBLE CODE CHART

2.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
a.

Check that optional components (including associated wiring) which generate radio waves are not installed.

Result:
Result Proceed to
Optional components (including associated wiring) are installed. A
Optional components (including associated wiring) are not installed. B


HINT:
·

Electrical noise from radio waves generated by optional components or the wiring for those components may affect AVC-LAN communication.

·

This DTC may be stored when an AVC-LAN communication error occurs due to electrical noise.





A

3.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

B

4.CHECK DTC
3.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
a.

Remove optional components (including associated wiring).

NOTICE:

Do not remove optional components or associated wiring without the permission of the customer.




NEXT

4.CHECK DTC
4.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END

NG

5.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY POWER SOURCE)
5.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY POWER SOURCE)
a.

Disconnect the L30 stereo component amplifier assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L30-3 (GND) - Body ground Always Below 1 Ω
L30-18 (GND2) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L30-1 (+B) - L30-3 (GND) Power switch off 11 to 14 V
L30-16 (+B2) - L30-3 (GND) Power switch off 11 to 14 V
L31-12 (ACC) - L30-3 (GND) Power switch on (ACC) 11 to 14 V




OK

6.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the L35 radio and display receiver assembly connector.


b.

Disconnect the L31 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L35-7 (TX1+) - L31-8 (ATX+) Always Below 1 Ω
L35-8 (TX1-) - L31-7 (ATX-) Always Below 1 Ω
L35-7 (TX1+) - Body ground Always 10 kΩ or higher
L35-8 (TX1-) - Body ground Always 10 kΩ or higher




OK

7.REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY
a.

Replace the stereo component amplifier assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL).



c.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY