Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E351352E03
0.344,2.823 1.531,3.271 1.188,0.448 10 false No. 1 Stereo Jack Adapter Assembly 0.344,2.667 0.635,2.865 0.292,0.198 10 false L13 0.854,2.208 1.302,2.427 0.448,0.219 10 false UJSS 0.833,1.427 1.281,1.646 0.448,0.219 10 false UDO+ 0.865,0.615 1.313,0.833 0.448,0.219 10 false UDO- 5.906,0.646 6.354,0.865 0.448,0.219 10 false UDO- 5.906,1.458 6.354,1.677 0.448,0.219 10 false UDO+ 5.906,2.208 6.313,2.417 0.406,0.208 10 false USG1 3.271,2.385 3.99,2.625 0.719,0.24 10 false (Shielded) 5.677,2.802 6.844,3.219 1.167,0.417 10 false Radio and Display Receiver Assembly 5.677,2.646 6.135,2.844 0.458,0.198 10 false L135 1.323,0.552 1.479,0.75 0.156,0.198 10 false 2 1.323,1.333 1.479,1.531 0.156,0.198 10 false 3 1.323,2.115 1.479,2.313 0.156,0.198 10 false 5 5.729,2.115 5.885,2.313 0.156,0.198 10 false 5 5.719,1.313 5.875,1.51 0.156,0.198 10 false 3 5.708,0.542 5.865,0.74 0.156,0.198 10 false 2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the L135 radio and display receiver assembly connector.


b.

Disconnect the L13 No. 1 stereo jack adapter assembly connector.


c.
U191378E01
0.18,2.25 0.354,2.423 0.174,0.174 10 *b 1.589,2.33 1.838,2.481 0.249,0.151 10 L13 0.521,3.621 0.914,3.773 0.394,0.151 10 UDO- 0.18,0.082 0.354,0.256 0.174,0.174 10 *a 1.539,0.234 1.889,0.385 0.351,0.151 10 L135 0.602,1.51 1.020,1.662 0.418,0.151 10 UDO+ 2.358,1.51 2.755,1.662 0.397,0.151 10 UDO- 1.586,1.425 1.114,1.597 false 2.332,1.597 1.861,1.425 false 2.464,3.616 2.877,3.767 0.413,0.151 10 UDO+ 2.464,3.919 2.858,4.070 0.394,0.151 10 UJSS 2.303,1.854 2.706,2.005 0.404,0.151 10 USG1 1.618,3.447 1.002,3.686 false 1.831,3.447 2.445,3.69 false 1.782,3.545 2.445,3.981 false 1.784,1.552 2.281,1.928 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L135-2 (UDO-) - L13-2 (UDO-) Always Below 1 Ω
L135-3 (UDO+) - L13-3 (UDO+) Always Below 1 Ω
L135-5 (USG1) - L13-5 (UJSS) Always Below 1 Ω
L135-2 (UDO-) - Body ground Always 10 kΩ or higher
L135-3 (UDO+) - Body ground Always 10 kΩ or higher
L135-5 (USG1) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR