This circuit is used when the voice switch of the steering pad switch is pushed.
Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.
Disconnect the L41 radio and display receiver assembly connector.
Disconnect the L31 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| L41-2 (RL+) - L31-15 (INT+) | Always | Below 1 Ω |
| L41-6 (RL-) - L31-14 (INT-) | Always | Below 1 Ω |
| L31-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| L41-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| L41-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG