Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2013.08–2014.11
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301734 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

A hard disk drive (HDD) is built into the navigation receiver assembly to store map and other data and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

·

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 11.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.
E227980

Remove the 4 bolts.


b.
E227981

Disengage the 5 claws and 2 guides.


c.

Disconnect each connector and remove the navigation receiver assembly with bracket.


Hide 86211J 12.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
E227982

Remove the 4 screws and No. 1 radio receiver bracket.


Hide 86212C 13.REMOVE NO. 2 RADIO RECEIVER BRACKET

HINT:

Use the same procedure as for the No. 1 radio receiver bracket.


Hide 86804A 15.REMOVE NAVIGATION ECU SUB-ASSEMBLY