Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.03–2013.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301737 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted  


CAUTION / NOTICE / HINT

HINT:

If an outlet of the air conditioning system is facing the microphone, noise may be recorded and the other caller may not be able to hear your voice properly.


PROCEDURE

1.CHECK CELLULAR PHONE
a.

Check if the other caller can hear your voice properly.

OK:

Your voice can be heard properly.


HINT:

The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.




OK

2.CHECK SETTINGS

NG

REPLACE CELLULAR PHONE

2.CHECK SETTINGS
a.

Display the "Call" screen.


b.
E240932E01
0.064,0.03 0.352,0.206 0.288,0.177 10 *a

Check that the "Mute" switch is not set to on.

OK:

"Mute" switch is not set to on.


Text in Illustration
*a Example



OK

3.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

NG

TURN "Mute" SWITCH OFF

3.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)
a.
E187218

Enter the "Microphone&Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK).


b.

When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.


c.

Push the recording switch and perform voice recording.

HINT:
·

Voice can be recorded for up to 5 seconds.

·

Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.




d.

Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

OK:

All check results are normal.




OK

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE