This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation ECU sub-assembly sends the signals to the stereo component amplifier assembly.
Disconnect the L40 navigation ECU sub-assembly connector.
Disconnect the L31 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| L40-2 (RL+) - L31-15 (INT+) | Always | Below 1 Ω |
| L40-6 (RL-) - L31-14 (INT-) | Always | Below 1 Ω |
| L31-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| L40-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| L40-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
(See pageAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE)
NG