Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301737 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1585  USB Media Malfunction  


DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No. DTC Detection Condition Trouble Area
B1585 USB Device Malfunction
·

Non mass-storage class or incompatible protocol USB device

·

USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)

·

"iPod" malfunction

·

"iPod" with unsupported firmware

·

Unsupported "iPod" model


·

USB device or "iPod"

·

Navigation ECU sub-assembly



PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Turn the power switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the power switch on (ACC).


d.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION).





NEXT

2.CHECK DTC
2.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

HINT:

If DTCs are detected frequently, replace the navigation ECU sub-assembly.


OK:

No DTCs are output.




OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USBDEVICE OR "iPod" WAS DEFECTIVE

NG