This DTC is stored when a malfunction occurs in the amplifier antenna assembly which is connected to the navigation ECU sub-assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B157D | The digital audio broadcasting antenna assembly is not connected. | ·
Antenna cord sub-assembly ·
No. 2 antenna cord sub-assembly ·
Roof antenna pole sub-assembly ·
Amplifier antenna assembly ·
Navigation ECU sub-assembly |
Replace the antenna cord sub-assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
OK
NG
Disconnect the No. 2 antenna cord sub-assembly.
Measure the resistance of the No. 2 antenna cord sub-assembly to check for an open circuit in the No. 2 antenna cord sub-assembly.
Below 1 Ω
Measure the resistance between the No. 2 antenna cord sub-assembly and body ground to check for a short circuit in the No. 2 antenna cord sub-assembly.
10 kΩ or higher
OK
NG
Replace the roof antenna pole sub-assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA(for Roof)>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
OK
NG
Replace the amplifier antenna assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA(for Roof)>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
OK
NG