Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301737 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1574  GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device)  


DESCRIPTION

The navigation ECU sub-assembly and parking assist ECU are connected via video signal (digital) lines.

This DTC is stored when a video signal (digital) line is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1574 Video signal (digital) is lost.
·

Harness and connector

·

Navigation ECU sub-assembly

·

Parking assist ECU



WIRING DIAGRAM

E233648E03
1.302,1.083 1.677,1.24 0.375,0.156 10 false GVIF 5.25,0.969 5.375,1.125 0.125,0.156 10 false 1 1.719,0.969 1.896,1.125 0.177,0.156 10 false 1 0.594,2 0.948,2.156 0.354,0.156 10 false L136 4.677,1.938 5.031,2.094 0.354,0.156 10 false L137 0.594,2.167 1.865,2.354 1.271,0.188 10 false Parking Assist ECU 4.677,2.094 6.958,2.292 2.281,0.198 10 false Navigation ECU Sub-assembly 5.417,1.083 5.844,1.24 0.427,0.156 10 false GVIF

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).


PROCEDURE

1.REPLACE HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - PARKING ASSIST ECU)
a.

Replace the harness and connector.



c.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END

NG

2.REPLACE PARKING ASSIST ECU
2.REPLACE PARKING ASSIST ECU


c.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END

NG