Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2014.11–2016.05
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301739 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the No. 1 integration relay.

WIRING DIAGRAM

E226478E25
5.259,1.979 5.595,2.149 0.336,0.170 10 1G 5.259,2.133 6.789,2.317 1.530,0.184 10 No. 1 Integration Relay 0.344,2.133 2.785,2.329 2.441,0.197 10 Radio and Display Receiver Assembly 1.339,1.066 1.786,1.251 0.448,0.185 10 REV 5.542,1.066 5.996,1.258 0.455,0.193 10 NAV 0.344,1.979 0.646,2.149 0.302,0.170 10 L35 5.354,0.961 5.592,1.128 0.238,0.166 10 4 1.721,0.961 1.933,1.110 0.211,0.149 10 2

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Check that the back-up light comes on.

OK:

The back-up light comes on.




OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the L35 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L35-2 (REV) - Body ground Power switch on (IG)
Reverse (R) selected
11 to 15.5 V
L35-2 (REV) - Body ground Power switch on (IG)
Shift state other than reverse (R) selected
Below 1 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR