Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2014.11–2016.05
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301739 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the GPS antenna, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E58
1.24,1.115 1.854,1.313 0.615,0.198 10 false SPD0 5.531,1.115 6.146,1.313 0.615,0.198 10 false SPD 1.719,0.99 2.333,1.188 0.615,0.198 10 false 2 5.323,1 5.646,1.198 0.323,0.198 10 false 5 0.5,1.979 1.115,2.177 0.615,0.198 10 false Y2 0.51,2.135 2.292,2.5 1.781,0.365 10 false Radio and Display Receiver Assembly 5.427,2 6.042,2.198 0.615,0.198 10 false Y3 5.427,2.156 6.417,2.396 0.99,0.24 10 false Navigation ECU 3.604,1.229 4.219,1.427 0.615,0.198 10 false * 2.948,2.146 4.719,2.5 1.771,0.354 10 false *: No. 1 Navigation Wire

PROCEDURE

1.CHECK NO. 1 NAVIGATION WIRE

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Y2-2 (SPD0) - Y3-5 (SPD) Always Below 1 Ω
Y2-2 (SPD0) - Body ground Always 10 kΩ or higher




OK

NG