This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.
Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.
Remove the No. 1 navigation wire (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y2-5 (MIC+) - Y3-16 (MIC+) | Always | Below 1 Ω |
| Y2-6 (MIC-) - Y3-17 (MIC-) | Always | Below 1 Ω |
| Y2-1 (SLD4) - Y3-18 (MSHLD) | Always | Below 1 Ω |
| Y2-5 (MIC+) - Body Ground | Always | 10 kΩ or higher |
| Y2-6 (MIC-) - Body Ground | Always | 10 kΩ or higher |
| Y2-1 (SLD4) - Body Ground | Always | 10 kΩ or higher |
OK
NG