The navigation receiver assembly receives a reverse signal from the No. 1 integration relay.
Check that the back-up light comes on.
The back-up light comes on.
OK
NG
Disconnect the L38 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L38-2 (REV) - Body ground | Power switch on (IG)
Reverse (R) selected |
11 to 14 V |
| L38-2 (REV) - Body ground | Power switch on (IG)
Shift state other than reverse (R) selected |
Below 1 V |
OK
NG