If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
Enter the "System Check Mode" screen.
Refer to Check Speaker in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Navigation Receiver Type)>OPERATION CHECK).
Perform the operation check above and determine the speaker that is not operating.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly | A |
| Front No. 2 speaker assembly | B |
| Rear speaker assembly | C |
| Rear No. 2 speaker assembly | D |
If sound cannot be heard from any speaker, inspect all of them.
A
B
C
D
Disconnect the L30 stereo component amplifier assembly connector.
Disconnect the N1 and O1 front No. 1 speaker assembly connectors.
Measure the resistance between the stereo component amplifier assembly and each of the front No. 1 speaker assemblies to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-15 (WFR+) - N1-1 | Always | Below 1 Ω |
| L30-30 (WFR-) - N1-2 | Always | Below 1 Ω |
| L30-8 (WFL+) - O1-1 | Always | Below 1 Ω |
| L30-23 (WFL-) - O1-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-15 (WFR+) - Body ground | Always | 10 kΩ or higher |
| L30-30 (WFR-) - Body ground | Always | 10 kΩ or higher |
| L30-8 (WFL+) - Body ground | Always | 10 kΩ or higher |
| L30-23 (WFL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 4.6 to 6.6 Ω |
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
OK
NG
Disconnect the L30 stereo component amplifier assembly connector.
Disconnect the I6 and I7 front No. 2 speaker assembly connectors.
Measure the resistance between the stereo component amplifier assembly and each of the front No. 2 speaker assemblies to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-9 (FR+) - I6-1 | Always | Below 1 Ω |
| L30-24 (FR-) - I6-2 | Always | Below 1 Ω |
| L30-14 (FL+) - I7-1 | Always | Below 1 Ω |
| L30-29 (FL-) - I7-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-9 (FR+) - Body ground | Always | 10 kΩ or higher |
| L30-24 (FR-) - Body ground | Always | 10 kΩ or higher |
| L30-14 (FL+) - Body ground | Always | 10 kΩ or higher |
| L30-29 (FL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 2 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 3.2 to 4.8 Ω |
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
OK
NG
Disconnect the L30 stereo component amplifier assembly connector.
Disconnect the P3 and Q3 rear speaker assembly connectors.
Measure the resistance between the stereo component amplifier assembly and each of the rear speaker assemblies to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-12 (RR+) - P3-1 | Always | Below 1 Ω |
| L30-27 (RR-) - P3-2 | Always | Below 1 Ω |
| L30-11 (RL+) - Q3-1 | Always | Below 1 Ω |
| L30-26 (RL-) - Q3-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-12 (RR+) - Body ground | Always | 10 kΩ or higher |
| L30-27 (RR-) - Body ground | Always | 10 kΩ or higher |
| L30-11 (RL+) - Body ground | Always | 10 kΩ or higher |
| L30-26 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the rear speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 3.2 to 5.2 Ω |
| *a | Component without harness connected
(Rear Speaker Assembly) |
OK
NG
Disconnect the L30 stereo component amplifier assembly connector.
Disconnect the P5 and Q5 rear No. 2 speaker assembly connectors.
Measure the resistance between the stereo component amplifier assembly and each of the rear No. 2 speaker assemblies to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-13 (TWR+) - P5-2 | Always | Below 1 Ω |
| L30-28 (TWR-) - P5-1 | Always | Below 1 Ω |
| L30-10 (TWL+) - Q5-2 | Always | Below 1 Ω |
| L30-25 (TWL-) - Q5-1 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-13 (TWR+) - Body ground | Always | 10 kΩ or higher |
| L30-28 (TWR-) - Body ground | Always | 10 kΩ or higher |
| L30-10 (TWL+) - Body ground | Always | 10 kΩ or higher |
| L30-25 (TWL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the rear No. 2 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 3.2 to 4.8 Ω |
| *a | Component without harness connected
(Rear No. 2 Speaker Assembly) |
OK
NG