This circuit is used when the voice switch of the steering pad switch assembly is pushed.
Using this circuit, the navigation receiver assembly sends signals to the stereo component amplifier assembly.
Disconnect the L170 navigation receiver assembly connector.
Disconnect the L31 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| L170-2 (RL+) - L31-15 (II1+) | Always | Below 1 Ω |
| L170-6 (RL-) - L31-14 (II1-) | Always | Below 1 Ω |
| L31-15 (II1+) - Body ground | Always | 10 kΩ or higher |
| L31-14 (II1-) - Body ground | Always | 10 kΩ or higher |
| L31-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
OK
NG