Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Navigation Receiver Type) › from 2016.05
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301740 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Navigation Voice Circuit  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the navigation receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E268439E23
0.322,2.79 1.697,3.105 1.375,0.316 10 Navigation Receiver Assembly 5.699,2.79 7.044,3.145 1.345,0.355 10 Stereo Component Amplifier Assembly 0.991,0.595 1.271,0.747 0.279,0.151 10 RL+ 1.354,0.512 1.449,0.663 0.095,0.151 10 2 1.021,1.394 1.271,1.545 0.250,0.151 10 RL- 0.322,2.624 0.829,2.775 0.507,0.151 10 L170 1.354,1.306 1.449,1.457 0.095,0.151 10 6 5.935,0.601 6.201,0.753 0.266,0.151 10 II1+ 5.67,0.501 5.841,0.652 0.172,0.151 10 15 5.935,1.396 6.157,1.548 0.222,0.151 10 II1- 5.666,1.292 5.841,1.443 0.175,0.151 10 14 5.935,2.191 6.307,2.343 0.371,0.151 10 SLD1 5.699,2.624 6.025,2.775 0.326,0.151 10 L31 3.246,1.715 3.897,1.866 0.651,0.151 10 (Shielded) 5.668,2.083 5.841,2.234 0.173,0.151 10 18

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the L170 navigation receiver assembly connector.


b.

Disconnect the L31 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester connection Condition Specified condition
L170-2 (RL+) - L31-15 (II1+) Always Below 1 Ω
L170-6 (RL-) - L31-14 (II1-) Always Below 1 Ω
L31-15 (II1+) - Body ground Always 10 kΩ or higher
L31-14 (II1-) - Body ground Always 10 kΩ or higher
L31-18 (SLD1) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR