The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.
Disconnect the L38 navigation receiver assembly connector.
Disconnect the L174 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L38-25 (ADPG) - L174-10 (ADPG) | Always | Below 1 Ω |
| L38-26 (VAR+) - L174-7 (VAR+) | Always | Below 1 Ω |
| L38-28 (VAL+) - L174-8 (VAL+) | Always | Below 1 Ω |
| L38-27 (VA-) - L174-9 (VA-) | Always | Below 1 Ω |
| L38-11 (AGND) - L174-12 (AGND) | Always | Below 1 Ω |
| L38-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| L38-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| L38-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| L38-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| L38-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
OK
NG