This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L31-1 (MUTE) - Body ground | Power switch on (ACC)
Audio system playing → Audio system changing modes |
2.0 V or higher
→ Below 1 V |
| *a | Component with harness connected
(Stereo Component Amplifier Assembly) |
OK
NG
Disconnect the L38 navigation receiver assembly connector.
Disconnect the L31 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L38-16 (MUT1) - L31-1 (MUTE) | Always | Below 1 Ω |
| L38-16 (MUT1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the L38 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L38-16 (MUT1) - Body ground | Power switch on (ACC)
Audio system playing |
2.0 V or higher |
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
OK
NG