Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the intelligent parking assist system.

HINT:
·

The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.

·

If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.

·

If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.



WIRING DIAGRAM

E222376E61
4.896,1.417 6.188,1.625 1.292,0.208 10 false Parking Assist ECU 4.896,1.271 5.229,1.438 0.333,0.167 10 false L64 5.021,0.302 5.229,0.469 0.208,0.167 10 false +B 5.021,0.771 5.458,0.938 0.438,0.167 10 false GND1 4.833,0.427 4.948,0.615 0.115,0.188 10 false 1 4.833,0.875 4.948,1.063 0.115,0.188 10 false 4 2.542,0.479 3.281,0.646 0.74,0.167 10 false RAD NO. 1 0.323,0.302 1.75,0.469 1.427,0.167 10 false from Auxiliary Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - AUXILIARY BATTERY AND BODY GROUND)
a.

Disconnect the L64 parking assist ECU connector.


b.
U191346E02
1.115,1.292 0.74,1.292 false 2.688,1.292 2.313,1.292 false 1.604,0.323 1.938,0.5 0.333,0.177 10 false L64 2.75,1.208 3.198,1.531 0.448,0.323 10 false GND1 0.5,1.208 0.948,1.531 0.448,0.323 10 false +B 0.146,0.063 0.594,0.385 0.448,0.323 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L64-4 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L64-1 (+B) - L64-4 (GND1) Power switch off 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Parking Assist ECU)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR