Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1621  Back Camera Power Supply Failure  C1622  Open or Short Circuit in Back Camera Signal  


DESCRIPTION

These DTCs are stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and rear television camera assembly are not normal.

DTC No. DTC Detection Condition Trouble Area
C1621 Rear television camera power supply failure
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU


C1622 An open or short in the rear television camera signal circuit
·

Harness or connector

·

Rear television camera assembly

·

Parking assist ECU



WIRING DIAGRAM

E226210E06
5.63,0.205 5.962,0.376 0.332,0.171 10 CV+ 5.63,0.724 5.962,0.895 0.332,0.171 10 CB+ 5.63,1.285 5.962,1.456 0.332,0.171 10 CV- 1.502,0.716 1.834,0.887 0.332,0.171 10 CB+ 1.502,0.176 1.967,0.348 0.465,0.171 10 CV+ 1.4,1.796 1.848,1.967 0.449,0.171 10 CGND 5.672,2.903 6.873,3.251 1.200,0.348 10 Rear Television Camera Assembly 3.16,3.279 3.992,3.450 0.832,0.171 10 *1: Shielded 5.672,2.751 5.976,2.923 0.303,0.171 10 V6 3.658,1.984 3.843,2.155 0.184,0.171 10 *1 2.867,1.984 3.051,2.155 0.184,0.171 10 *1 4.45,1.984 4.634,2.155 0.184,0.171 10 *1 0.412,2.793 1.676,2.984 1.264,0.191 10 Parking Assist ECU 1.502,1.256 1.834,1.427 0.332,0.171 10 CV- 5.385,0.62 5.517,0.791 0.132,0.171 10 4 5.385,0.081 5.517,0.252 0.132,0.171 10 2 5.385,1.158 5.517,1.330 0.132,0.171 10 1 5.63,1.818 6.110,1.990 0.480,0.171 10 CGND 5.385,1.697 5.517,1.868 0.132,0.171 10 3 2.017,0.541 2.220,0.712 0.203,0.171 10 14 2.016,0.007 2.205,0.178 0.189,0.171 10 15 2.016,1.608 2.205,1.779 0.189,0.171 10 37 1.4,2.336 1.816,2.507 0.416,0.171 10 GND1 2.065,2.141 2.177,2.313 0.112,0.171 10 4 2.016,1.074 2.205,1.245 0.189,0.171 10 38 1.997,0.731 2.330,0.902 0.332,0.171 10 L65 1.997,0.194 2.330,0.366 0.332,0.171 10 L65 1.997,1.267 2.330,1.439 0.332,0.171 10 L65 1.997,1.804 2.330,1.975 0.332,0.171 10 L65 1.997,2.34 2.330,2.511 0.332,0.171 10 L64

CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the L65 parking assist ECU connector.


b.

Disconnect the V6 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L65-14 (CB+) - V6-4 (CB+) Always Below 1 Ω
L65-15 (CV+) - V6-2 (CV+) Always Below 1 Ω
L65-37 (CGND) - V6-3 (CGND) Always Below 1 Ω
L65-38 (CV-) - V6-1 (CV-) Always Below 1 Ω
L65-14 (CB+) - Body ground Always 10 kΩ or higher
L65-15 (CV+) - Body ground Always 10 kΩ or higher
L65-37 (CGND) - Body ground Always 10 kΩ or higher
L65-38 (CV-) - Body ground Always 10 kΩ or higher




OK

2.CHECK PARKING ASSIST ECU (CV-, CGND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK PARKING ASSIST ECU (CV-, CGND)
a.
U191304E01
0.096,0.049 0.292,0.219 0.195,0.170 10 *a 1.114,1.682 1.555,1.852 0.442,0.170 10 CGND 0.559,1.682 0.845,1.852 0.286,0.170 10 CV- 1.021,1.105 0.721,1.658 false 1.104,1.105 1.331,1.649 false 1.645,0.116 1.974,0.298 0.329,0.181 10 L65

Reconnect the L65 parking assist ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L65-37 (CGND) - Body ground Always Below 1 Ω
L65-38 (CV-) - Body ground Always Below 1 Ω


Text in Illustration
*a Component with harness connected
(Parking Assist ECU)



OK

3.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - POWER SOURCE)

NG

3.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - POWER SOURCE)
a.

Disconnect the V6 rear television camera assembly connector.


b.
U191341E01
0.146,0.122 0.367,0.370 0.221,0.248 10 *a 1.601,1.56 1.046,1.56 false 2.409,1.56 1.853,1.56 false 0.49,1.474 1.090,1.648 0.600,0.174 10 CGND 2.461,1.474 3.061,1.648 0.600,0.174 10 CB+ 1.627,0.16 1.814,0.341 0.187,0.181 10 V6

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
V6-3 (CGND) - V6-4 (CB+) Power switch on (READY)
Reverse (R) selected
5.8 to 7.0 V


Text in Illustration
*a Front view of wire harness connector
(to Rear Television Camera Assembly)



OK

4.CHECK PARKING ASSIST ECU (CV+, GND1)

NG

4.CHECK PARKING ASSIST ECU (CV+, GND1)
a.

Reconnect the V6 rear television camera assembly connector.


b.

Reconnect the L65 parking assist ECU connector.

E361817E01
1.5,1.167 1.917,1.417 0.417,0.25 2.667,1.167 3.083,1.417 0.417,0.25 1.365,2.49 1.365,1.896 false 2.604,2.49 2.604,1.875 false 4.833,1.917 5,1.917 5,1.917 5.063,1.51 false 5.417,1.917 5.25,1.917 5.25,1.917 5.156,1.417 false 4.833,3.583 5,3.583 5,3.583 5.094,3.042 false 5.5,3.583 5.333,3.583 5.333,3.583 5.208,2.99 false 0.729,0.906 1.042,1.104 0.313,0.198 10 false *a 1.24,2.521 1.552,2.719 0.313,0.198 10 false CV+ 2.458,2.521 2.896,2.719 0.438,0.198 10 false GND1 1.583,1.208 1.896,1.406 0.313,0.198 10 false L65 2.75,1.208 3.063,1.406 0.313,0.198 10 false L64 4.229,0.229 4.542,0.427 0.313,0.198 10 false *b 4.656,1.833 4.969,2.031 0.313,0.198 10 false *d 5.458,1.833 5.771,2.031 0.313,0.198 10 false *e 4.354,1.031 4.792,1.229 0.438,0.198 10 false GND 4.375,2.698 4.813,2.896 0.438,0.198 10 false GND 4.25,2.042 4.563,2.24 0.313,0.198 10 false *c 4.646,3.5 4.958,3.698 0.313,0.198 10 false *d 5.531,3.49 5.844,3.688 0.313,0.198 10 false *e


c.

Check the waveform of the rear television camera assembly using an oscilloscope.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the parking assist ECU with the connector connected.


OK:

Waveform is as shown in the illustration.


Item Content
Terminal No. (Symbol) L65-15 (CV+) - L64-4 (GND1)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Power switch on (READY), reverse (R) selected

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.


Text in Illustration
*a Component with harness connected
(Parking Assist ECU)
*b Waveform 1 (camera lens not covered, displaying an image)
*c Waveform 2 (camera lens covered, blacking out the screen)
*d Synchronization Signal
*e Video Waveform



OK

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY