These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | Control module communication bus off | CAN communication system |
| U0100 | Lost Communication with ECM | |
| U0126 | Lost communication with spiral cable with sensor sub-assembly | |
| U0129 | Lost communication with brake actuator (skid control ECU) | |
| U0131 | Lost communication with power steering ECU assembly | |
| U0140 | Lost communication with main body ECU (multiplex network body ECU) | |
| U0293 | Lost communication with power management control ECU |
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)