Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2012.03–2013.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1645  Power Steering Control System Failure  


DESCRIPTION

This DTC is stored when the parking assist ECU receives a malfunction signal from the power steering system via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C1645 Power steering system malfunction judgment Power steering system

PROCEDURE

1.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTCs are not output A
DTC C1645 is output B


HINT:
·

The DTC is stored when a malfunction occurs in the power steering system.

·

This DTC may be output due to a temporary phenomenon such as low voltage or EPS overheat protection.

·

If troubleshooting and repair of a malfunction in the power steering system has been completed, DTC C1645 will not be output again when rechecking for DTCs.

·

If DTC C1645 is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTCs are not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).





A

B