This DTC is stored when the parking assist ECU receives a malfunction signal from the power steering system via CAN communication.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1645 | Power steering system malfunction judgment | Power steering system |
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC C1645 is output | B |
The DTC is stored when a malfunction occurs in the power steering system.
This DTC may be output due to a temporary phenomenon such as low voltage or EPS overheat protection.
If troubleshooting and repair of a malfunction in the power steering system has been completed, DTC C1645 will not be output again when rechecking for DTCs.
If DTC C1645 is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTCs are not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B