Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).

DTC No. DTC Detection Condition Trouble Area
C1691 Back camera initial setting has not been memorized
·

Height control sensor vehicle height difference setting

·

Rear television camera optical axis adjustment

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS (HEIGHT SET AND CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

HINT:

Before performing the rear television camera optical axis adjustment, the height control sensor vehicle height difference setting must be performed in the "HEIGHT SET" screen.


i.

Height control sensor vehicle height difference setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION)





NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1691 is output A
DTCs are not output B


HINT:
·

If DTC C1691 is output, perform rear television camera optical axis adjustment again.

·

If DTC C1691 is still output after performing height control sensor vehicle height difference setting and rear television camera optical axis adjustment 3 times, replace the parking assist ECU.





A

B

END