Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. DTC Detection Condition Trouble Area
C1694 Maximum steering angle has not been memorized
·

Steering angle setting

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS (STEERING ANGLE SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.




NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1694 is output A
DTCs are not output B


HINT:
·

If DTC C1694 is output, perform steering angle setting again.

·

If DTC C1694 is still output after performing steering angle setting 3 times, replace the parking assist ECU.





A

B

END