This DTC is stored when the parking assist ECU judges that the zero point calibration of the vehicle height sensor is incomplete (height control sensor vehicle height difference setting is incomplete).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1695 | Zero point calibration of vehicle height sensor is incomplete | ·
Height control sensor vehicle height difference setting ·
Parking assist ECU |
When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
Height control sensor vehicle height difference setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION)
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1695 is output | A |
| DTCs are not output | B |
If DTC C1695 is output, perform height control sensor vehicle height difference setting again.
If DTC C1695 is still output after performing height control sensor vehicle height difference setting 3 times, replace the parking assist ECU.
A
B