Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2013.08–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C164E  Stop Switch Circuit Malfunction  


DESCRIPTION

This DTC is stored when the parking assist ECU receives a stop light switch assembly open signal from the brake control system via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C164E Open in stop light switch Electronically controlled brake system

PROCEDURE

1.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C164E is output A
DTCs are not output B


HINT:
·

The DTC is stored when a malfunction occurs in the brake control system.

·

If troubleshooting and repair of a malfunction in the brake control system has been completed, DTC C164E will not be output again when rechecking for DTCs.

·

If DTC C164E is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTCs are not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).





A

B