Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2014.11–2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301742 REAR VIEW MONITOR SYSTEM D

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Navigation System / Trouble Codes.


e.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).

NOTICE:

The navigation receiver assembly*1 or radio and display receiver assembly*2*3 outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

System Proceed to
Navigation System (for Navigation Receiver Type)*1 (Click here)
Audio and Visual System*2 (Click here)
Navigation System (for Radio and Display Type)*3 (Click here)

*1: for Navigation Receiver Type

*2: for Radio and Display Type (w/o Navigation System)

*3: for Radio and Display Type (w/ Navigation System)





CLEAR DTC


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Navigation System / Trouble Codes.


e.

Clear the DTCs.