Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301742 REAR VIEW MONITOR SYSTEM J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  Image from Camera for Rear View Monitor is Abnormal  


DESCRIPTION

The video signal of the rear television camera assembly is transmitted to the radio and display receiver assembly.


WIRING DIAGRAM

E226207E32
0.146,2.75 2.115,3.104 1.969,0.354 10 false Radio and Display Receiver Assembly 5.396,0.635 5.573,0.802 0.177,0.167 10 false 2 5.396,1.167 5.573,1.333 0.177,0.167 10 false 1 5.396,0.104 5.573,0.271 0.177,0.167 10 false 4 5.396,1.698 5.573,1.865 0.177,0.167 10 false 3 5.615,0.74 6.031,0.906 0.417,0.167 10 false CV+ 5.615,1.292 6.031,1.458 0.417,0.167 10 false CV- 5.615,0.198 6.031,0.365 0.417,0.167 10 false CB+ 5.615,1.823 6.083,1.99 0.469,0.167 10 false CGND 2,1.073 2.198,1.24 0.198,0.167 10 false 16 2.01,1.615 2.208,1.781 0.198,0.167 10 false 15 2.052,2.146 2.25,2.313 0.198,0.167 10 false 7 1.615,0.74 2.031,0.906 0.417,0.167 10 false V+ 1.625,1.26 2.042,1.427 0.417,0.167 10 false V- 1.521,0.198 1.938,0.365 0.417,0.167 10 false CA+ 1.417,1.813 1.885,1.979 0.469,0.167 10 false CGND 1.417,2.344 1.896,2.51 0.479,0.167 10 false GND1 5.469,2.906 6.948,3.323 1.479,0.417 10 false Rear Television Camera Assembly 3.438,3.125 4.344,3.333 0.906,0.208 10 false *1: Shielded 4.531,1.938 4.781,2.135 0.25,0.198 10 false *1 3.844,1.938 4.094,2.135 0.25,0.198 10 false *1 3.156,1.938 3.406,2.135 0.25,0.198 10 false *1 2.052,0.542 2.229,0.708 0.177,0.167 10 false 8 2.042,0.021 2.219,0.188 0.177,0.167 10 false 7 5.469,2.74 5.667,2.906 0.198,0.167 10 false V6 1.969,0.74 2.302,0.906 0.333,0.167 10 false L34 1.969,1.271 2.302,1.438 0.333,0.167 10 false L34 1.969,0.208 2.302,0.375 0.333,0.167 10 false L34 1.969,1.802 2.292,1.969 0.323,0.167 10 false L34 1.979,2.333 2.323,2.5 0.344,0.167 10 false L36

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the L34 radio and display receiver assembly connector.


b.

Disconnect the V6 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L34-7 (CA+) - V6-4 (CB+) Always Below 1 Ω
L34-8 (V+) - V6-2 (CV+) Always Below 1 Ω
L34-15 (CGND) - V6-3 (CGND) Always Below 1 Ω
L34-16 (V-) - V6-1 (CV-) Always Below 1 Ω
L34-7 (CA+) - Body ground Always 10 kΩ or higher
L34-8 (V+) - Body ground Always 10 kΩ or higher
L34-15 (CGND) - Body ground Always 10 kΩ or higher
L34-16 (V-) - Body ground Always 10 kΩ or higher




OK

2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.
U191274E02
1.365,1.802 1.052,2.469 1.052,2.469 0.719,2.469 false 1.24,1.781 0.719,1.781 false 1.365,1.635 1.052,0.958 1.052,0.958 0.719,0.958 false 0.469,1.698 0.802,1.875 0.333,0.177 10 false V- 0.26,2.375 0.698,2.552 0.438,0.177 10 false CGND 0.167,0.104 0.604,0.281 0.438,0.177 10 false *a 1.552,0.427 1.906,0.604 0.354,0.177 10 false L34 0.365,0.865 0.698,1.042 0.333,0.177 10 false CA+

Reconnect the L34 radio and display receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L34-15 (CGND) - Body ground Always Below 1 Ω
L34-16 (V-) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L34-7 (CA+) - L34-15 (CGND) Within 60 seconds of turning the power switch on (ACC) 5.5 to 7.05 V


Text in Illustration
*a Component with harness connected
(Radio and Display Receiver Assembly)



OK

3.INSPECT REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.INSPECT REAR TELEVISION CAMERA ASSEMBLY
a.

Reconnect the V6 rear television camera assembly connector.


b.

Check the waveform of the rear television camera assembly using an oscilloscope.

E361815E01
1.833,0.167 2.25,0.417 0.417,0.25 1.5,2 1.917,2.25 0.417,0.25 1.729,0.865 1.729,0.802 1.729,0.802 1.354,0.802 false 1.219,3.177 1.531,3.177 1.531,3.177 1.823,2.865 false 4.677,1.833 4.844,1.833 4.844,1.833 4.896,1.427 false 5.25,1.833 5.083,1.833 5.083,1.833 4.979,1.344 false 4.677,3.583 4.844,3.583 4.844,3.583 4.917,3.063 false 5.333,3.583 5.167,3.583 5.167,3.583 5.021,3.01 false 0.365,0.125 0.677,0.323 0.313,0.198 10 false *a 3.896,0.146 4.208,0.344 0.313,0.198 10 false *b 4.031,2.104 4.344,2.302 0.313,0.198 10 false *c 1.115,0.719 1.427,0.917 0.313,0.198 10 false V+ 1.917,0.208 2.229,0.406 0.313,0.198 10 false L34 1.583,2.042 1.896,2.24 0.313,0.198 10 false L36 0.792,3.083 1.198,3.292 0.406,0.208 10 false GND1 4.49,1.75 4.802,1.948 0.313,0.198 10 false *d 5.302,1.75 5.615,1.948 0.313,0.198 10 false *e 4.219,0.969 4.625,1.177 0.406,0.208 10 false GND 4.219,2.729 4.625,2.938 0.406,0.208 10 false GND 4.49,3.49 4.802,3.688 0.313,0.198 10 false *d 5.375,3.5 5.688,3.698 0.313,0.198 10 false *e

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.


OK:

Waveform is similar to that shown in the illustration.


Item Content
Terminal No. (Symbol) L34-8 (V+) - L36-7 (GND1)
Tool Setting 200 mV/DIV., 50 μs/DIV.
Condition Power switch on (READY), reverse (R) selected

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.


Text in Illustration
*a Component with harness connected
(Radio and Display Receiver Assembly)
*b Waveform 1 (camera lens not covered, displaying an image)
*c Waveform 2 (camera lens covered, blacking out the screen)
*d Synchronization Signal
*e Video Waveform



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY