Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM2070E _57 Power Source / Network _061935 POWER DISTRIBUTION _0301752 INTEGRATION RELAY G

POWER DISTRIBUTION  INTEGRATION RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 82641 1.INSPECT NO. 1 INTEGRATION RELAY

HINT:
·

This inspection is not for the No. 1 integration relay itself, but for the wire harness that is connected to the No. 1 integration relay. If the result is within the specified condition, the No. 1 integration relay may be malfunctioning.

·

If the result is not as specified, a short between No. 1 integration relay and one of the electrical loads is suspected.

·

Make sure that the malfunction is reproduced when performing the inspection below.

·

After the wire harness has been repaired, disconnect all connectors that are connected to the No. 1 integration relay, and turn the power switch on (READY) to clear the DTCs.



a.

Diagnosis Terminal

i.

Confirm that the system that is malfunctioning.


ii.

Make sure that the malfunction is reproduced.


iii.
E184982E07
0.542,1.365 0.542,1.823 false 0.698,1.365 1.333,1.802 false 0.49,1.844 0.896,2 0.406,0.156 10 false D1 1.333,1.813 1.74,1.969 0.406,0.156 10 false D2 0.167,0.156 0.313,0.313 0.146,0.156 10 false *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage :
Tester Connection Condition Specified Condition
D1 - Body ground Power switch on (IG) or (READY) 3.5 to 5.0 V
D2 - Body ground Power switch on (IG) or (READY) 3.5 to 5.0 V


Text in Illustration
*a Component with harness connected
(No. 1 Integration Relay)

If the result is not as specified, a short between No. 1 integration relay and one of the electrical loads is suspected.