Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM › 2012.03–2016.05
RM2070E _57 Power Source / Network _061936 NETWORKING _0301753 LIN COMMUNICATION SYSTEM D

NETWORKING  LIN COMMUNICATION SYSTEM  SYSTEM DESCRIPTION  


LIN COMMUNICATION SYSTEM DESCRIPTION


The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication because of an open in the communication lines or other reasons, the master control ECU of the relevant system will store a DTC. Refer to the table below about the communication bus lines and connected components.

HINT:
·

Each component has a fail-safe function which activates to maintain the minimum performance of the system and protect the system.

·

In the following table, "○" indicates that the function applies, and "-" indicates that it does not.



Door Bus Lines
Component Master Control LIN Communication DTC Output Function
Main Body ECU (Multiplex Network Body ECU) ○ ○
Power Window Regulator Motor Assembly (for Driver Side) - -
Power Window Regulator Motor Assembly (for Front Passenger Side) - -
Power Window Regulator Motor Assembly (for Rear LH Side) - -
Power Window Regulator Motor Assembly (for Rear RH Side) - -
Multiplex Network Master Switch Assembly - -
Roof Sunshade ECU (Sliding Roof Drive Gear Assembly)*1 - -
Double Lock Door Control Relay Assembly*2 - -

*1: w/ Roof Sunshade System

*2: w/ Double Locking System


Certification Bus Lines
Component Master Control LIN Communication DTC Output Function
Certification ECU (Smart Key ECU Assembly) ○ ○
Power Management Control ECU - ○
Transmission Control ECU Assembly - -
ID Code Box (Immobiliser Code ECU) - -

Air Conditioning Bus Lines
Component Master Control LIN Communication DTC Output Function
Air Conditioning Amplifier Assembly ○ -
Heater Control Panel Assembly - -