CHECK DTC
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Power Source Control, Entry&Start or Main Body / DTC.
Check the details of the DTC(s) (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Power Source Control, Entry&Start or Main Body / DTC.
Clear the DTC(s).