This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and transmission control ECU assembly stops for 10 seconds or more.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2786 | No communication between transmission control ECU assembly and certification ECU (smart key ECU assembly) for 10 seconds or more. | ·
Transmission control ECU assembly ·
Certification ECU (smart key ECU assembly) ·
Wire harness or connector ·
P CON MAIN fuse |
Although "No Response from Steering Lock ECU" is displayed on the GTS, this message is shown if the certification ECU (smart key ECU assembly) cannot communicate with the transmission control ECU assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the certification ECU (smart key ECU assembly) is replaced, register the key.
If the transmission control ECU assembly is replaced, register the ECU code.
When using the GTS to troubleshoot with the power switch off:
Connect the GTS to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.
Disconnect the A23 and A24 transmission control ECU assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-6 (E01) - Body ground | Always | Below 1 Ω |
| A24-5 (E02) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A23-15 (BATT) - Body ground | Power switch off | 11 to 14 V |
OK
NG
Disconnect the L197 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L197-17 (LIN) - A24-24 (LIN) | Always | Below 1 Ω |
| L197-17 (LIN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the transmission control ECU assembly (See page Drivetrain>P410 (HYBRID TRANSMISSION / TRANSAXLE)>TCM>REMOVAL).
NEXT
Clear the DTC (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC B2786 is not output.
OK
NG