This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2789 | No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for 10 seconds or more. | ·
ID code box (immobiliser code ECU) ·
Certification ECU (smart key ECU assembly) ·
Wire harness or connector ·
ECU-B2 fuse |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the certification ECU (smart key ECU assembly) is replaced, register the key.
If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
When using the GTS to troubleshoot with the power switch off:
Connect the GTS to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.
Disconnect the L191 ID code box connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L191-5 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L191-1 (+B) - Body ground | Power switch off | 11 to 14 V |
| *1 | Front view of wire harness connector
(to ID Code Box (Immobiliser Code ECU)) |
OK
NG
Disconnect the L197 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L197-17 (LIN) - L191-2 (LIN1) | Always | Below 1 Ω |
| L197-17 (LIN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the ID code box (immobiliser code ECU).
NEXT
Clear the DTC (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC B2789 is not output.
OK
NG