| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B278C | An internal malfunction occurs in the certification ECU (smart key ECU assembly) | ·
Certification ECU (smart key ECU assembly) |
If the certification ECU (smart key ECU assembly) is replaced, refer to Service Bulletin.
When using the GTS to troubleshoot with the power switch off:
Connect the GTS to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B278C is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG