OVERALL CAN BUS DIAGRAM
The CAN communication system is composed of 2 buses.
| 1 | Combination Meter Sub-assembly
(for V Bus) |
2 | Main Body ECU (Multiplex Network Body ECU)
(for V Bus) |
| 3 | DLC3
(for V Bus) |
4 | Airbag ECU Assembly
(for V Bus) |
| 5 | Spiral Cable with Sensor Sub-assembly (Steering Angle Sensor)
(for V Bus) |
6 | Power Steering ECU Assembly
(for V Bus) |
| 7 | Certification ECU (Smart Key ECU Assembly)
(for V Bus) |
8 | Air Conditioning Amplifier Assembly
(for V Bus) |
| 9 | Radio and Display Receiver Assembly
(for Radio and Display Type) (for V Bus) |
10 | Navigation Receiver Assembly
(for Navigation Receiver Type) (for V Bus) |
| 11 | Hybrid Vehicle Control ECU
(for V Bus and Sub Bus 15) |
12 | Transmission Control ECU Assembly
(for V Bus) |
| 13 | Brake Booster with Master Cylinder Assembly (Skid Control ECU)
(for V Bus and Sub Bus 15) |
14 | ECM
(for V Bus and Sub Bus 15) |
Refer to the following bus wiring diagrams for details.
V BUS (for LHD)
The CAN communication system connects to other networks via ECUs that function as a gateway (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>SYSTEM DIAGRAM).
V BUS (for RHD)
The CAN communication system connects to other networks via ECUs that function as a gateway (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>SYSTEM DIAGRAM).
SUB BUS 15