| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Power Management Control ECU Communication Stop Mode | Either condition is met:
·
|
·
Power management control ECU branch line or connector ·
Power source circuit of power management control ECU ·
Power management control ECU ground circuit ·
Power management control ECU |
Before measuring the resistance of the CAN bus, turn the power switch off and leave the vehicle for 1 minute or more without operating the key, switches or opening or closing the doors. After that, disconnect the cable from the negative (-) auxiliary battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING).
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the power switch on (IG), wait at least 60 seconds, and then drive the vehicle at a speed of 50 km/h (31 mph) or more at least 1.72 seconds.
After the repair, perform CAN Bus Check and check that all the ECUs and sensors connected to the CAN communication system are displayed (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).
Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the L6 power management control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| L6-25 (CA1H) - L6-24 (CA1L) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Rear view of wire harness connector
(to Power Management Control ECU) |
OK
NG
Disconnect the L5 power management control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| L5-6 (E1) - Body ground | Cable disconnected from negative (-) auxiliary battery terminal | Below 1 Ω |
| *a | Rear view of wire harness connector
(to Power Management Control ECU) |
OK
NG
Reconnect the L5 power management control ECU connector.
Reconnect the L6 power management control ECU connector.
Connect the cable to the negative (-) auxiliary battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| A22-5 (+B1) - Body ground | Power switch on (IG) | 11 to 14 V |
| A21-2 (+B2) - Body ground | Power switch on (IG) | 11 to 14 V |
| *a | Component with harness connected
(Power Management Control ECU) |
OK
NG