Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY › from 2016.05
RM2070E _58 Vehicle Interior _061937 DOOR LOCK _0301759 TRANSMITTER BATTERY A

DOOR LOCK  TRANSMITTER BATTERY  REPLACEMENT  


PROCEDURE

Hide 89745C 1.REMOVE TRANSMITTER BATTERY

NOTICE:

Take extra care when handling these precision electronic components.


a.
B274647

Push the release hook knob and remove the mechanical key as shown in the illustration.


b.
B274649E09
0.708,1.635 0.979,1.833 false 1.021,1.76 1.354,1.948 0.333,0.188 10 false *a

Insert a screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.

Text in Illustration
*a Protective Tape

HINT:

Tape the screwdriver tip before use.



c.
B274650E06
1.865,1.031 2.135,1.24 false 2.177,1.156 2.51,1.344 0.333,0.188 10 false *a

Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR2032).

Text in Illustration
*a Protective Tape

NOTICE:
·

Do not push the terminals with your finger.

·

Do not forcibly pry up the transmitter battery as the terminals may be damaged.

·

Do not touch the transmitter battery with wet hands. Moisture may cause rust.

·

Do not touch or move any components inside the transmitter housing case. It may interfere with proper operation.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.



HINT:

Tape the screwdriver tip before use.



Hide 89745C 2.INSTALL TRANSMITTER BATTERY

a.
B279133

Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.

NOTICE:
·

Do not bend the transmitter battery electrode during installation.

·

Keep the inside of the transmitter housing cover free of dust and oil.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.




b.
B279134

Install the transmitter housing cover by pressing down on it as shown in the illustration.


c.
B274648

Insert the mechanical key into the transmitter.


d.

Press one of the transmitter switches and check that the LED illuminates.

OK:

Transmitter LED illuminates when a switch is pressed.