Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function)
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301767 ENTRY AND START SYSTEM(for Entry Function) J

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Entry Function)  Entry Interior Alarm does not Sound  


DESCRIPTION

The entry and start system (for Entry Function) uses the buzzer in the combination meter sub-assembly (meter ECU) to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the combination meter sub-assembly (meter ECU) via CAN communication and the buzzer sounds.

CAUTION / NOTICE / HINT

NOTICE:
·

The entry and start system (for Entry Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

·

Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.



PROCEDURE

1.CHECK COMBINATION METER SUB-ASSEMBLY (OPERATION)
a.

When the power switch is on (READY) and reverse (R) is selected, check that the combination meter buzzer sounds.

OK:

Combination meter buzzer sounds.




OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG