Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301768 ENTRY AND START SYSTEM(for Start Function) D

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  DTC CHECK / CLEAR  


NOTICE:

If the GTS is connected to the vehicle with the power switch off, the information stored in entry and start system related ECUs (the certification ECU (smart key ECU assembly), power management control ECU and main body ECU) cannot be read. However, entry and start system DTCs and Data List information can be confirmed even if the power switch is off using the method below:

·

Connect the GTS to the vehicle, and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and vehicle begins (the GTS screen changes when communication begins).

·

Connect the GTS to the vehicle, select the vehicle type under manual mode, and then enter the following menus:

for Power Source Control: Body Electrical / Power Source Control / Trouble Codes.

for Entry&Start: Body Electrical / Entry&Start / Trouble Codes.



CHECK FOR DTC (POWER MANAGEMENT CONTROL ECU)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.


e.

Check for DTCs.

HINT:

Refer to the GTS operator's manual for further details.




CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Entry&Start / Trouble Codes.


e.

Check for DTCs.

HINT:

Refer to the GTS operator's manual for further details.




CLEAR DTC (POWER MANAGEMENT CONTROL ECU)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.


e.

Clear the DTCs by following the directions on the GTS display.

HINT:

Refer to the GTS operator's manual for further details.




CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Entry&Start / Trouble Codes.


e.

Clear the DTCs by following the directions on the GTS display.

HINT:

Refer to the GTS operator's manual for further details.