| Component | Outline |
|---|---|
| Power switch
·
Transponder key amplifier |
·
Turns on the power and starts the hybrid control system. ·
Contains a built-in transponder key amplifier to start the hybrid control system when the electrical key transmitter sub-assembly does not operate properly due to a depleted transmitter battery or wave interference. |
| Certification ECU (smart key ECU assembly) | ·
Performs key verification. ·
Controls the electrical key antenna (outside), electrical key antenna (indoor) and door lock/ unlock sensor. ·
Outputs smart entry door lock/unlock commands. ·
Outputs gearshift control lock/unlock command signals. ·
Outputs immobiliser set/unset commands. ·
Forms the smart key system detection area. ·
Records codes for smart verification. ·
Changes the power source mode in 4 stages (off, on (ACC), on (IG), on (READY)) in accordance with the shift state and stop light switch. ·
Controls the push-button start function in accordance with signals received from switches and ECUs. ·
Permit starting of the hybrid control system after receiving an unlock signal from the hybrid vehicle control ECU. |
| ID code box (immobiliser code ECU) | Records codes for smart verification. |
| Hybrid vehicle control ECU | ·
Locks/unlocks gearshift control based on lock/ unlock request signals from the certification ECU (smart key ECU assembly). ·
Detects gearshift control lock/unlock status and transmits it to other ECUs. ·
Activates the shift control actuator based on signals from the certification ECU (smart key ECU assembly) when gearshift control is unlocked. ·
Controls the application timing of current to the parking lock motor based on signals from the rotation angle sensor. |
| Combination meter assembly | ·
Operates various warnings (messages on the multi-information display, sounding of the buzzer in the combination meter assembly), according to the command signals from the certification ECU (smart key ECU assembly). ·
Outputs a vehicle speed signal to the main body ECU (multiplex network body ECU). |
| IG, ACC relay | Turns on/off according to the certification ECU (smart key ECU assembly) and provides power to each system. |
| Stop light switch assembly | Detects that the brake pedal has been depressed (switch is on) and outputs a signal to the certification ECU (smart key ECU assembly). |
| Electrical key and tire pressure monitoring system receiver assembly | Receives the smart key system code/wireless code sent from the electrical key transmitter sub-assembly and sends it to the certification ECU (smart key ECU assembly). |
| Electrical key transmitter sub-assembly | Sends the ID code upon receiving a request signal. |