When an open or short circuit is detected in the transponder key amplifier coil built into the power switch, the certification ECU (smart key ECU assembly) stores this DTC. This DTC is also stored as a past DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B2784 | The transponder key amplifier coil built into the power switch is open (see below) or shorted (determined by communication with certification ECU (smart key ECU assembly)) (1 trip detection logic*).
·
Terminal VC5, TXCT or CODE is open (includes disconnection of the power switch). ·
The transponder key amplifier coil built into the power switch is open. |
·
Power switch ·
Wire harness or connector ·
Certification ECU (smart key ECU assembly) |
With park (P) selected, the key is held against the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the transmitter battery is depleted. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started when transmitter battery is depleted by holding key against power switch and pressing and holding power switch with park (P) selected | - |
| DTC Code | Data List and Active Test |
|---|---|
| B2784 | - |
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
The certification ECU (smart key ECU assembly) outputs a fixed 5 V power source voltage through a resistance from terminal CODE. The power switch grounds or does not ground this power source voltage accordingly.
The certification ECU (smart key ECU assembly) outputs a fixed 5 V power source voltage through a resistance and transistor. The power switch grounds or does not ground this signal accordingly.
After performing repair, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Perform the operation that fulfills the DTC output confirmation operation.
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC B2784 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the L62 ECU connector.
Disconnect the L43 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L62-13 (CODE) - L43-10 (CODE) | Always | Below 1 Ω |
| L62-12 (TXCT) - L43-9 (TXCT) | ||
| L62-13 (CODE) or L43-10 (CODE) - Body ground | Always | 10 kΩ or higher |
| L62-12 (TXCT) or L43-9 (TXCT) - Body ground |
OK
NG
Temporarily replace the power switch with a new or known good one (See page Engine / Hybrid System>2ZR-FXE (STARTING)>POWER SWITCH>REMOVAL).
NEXT
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Perform the operation that fulfills the DTC output confirmation operation.
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC B2784 is not output.
OK
NG