When there is a short to GND in the power supply for the transponder key amplifier of the power switch, the certification ECU (smart key ECU assembly) stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B278A | A short to GND in the power supply of the transponder key amplifier of the power switch (VC5 - VC5) (1 trip detection logic*). | ·
Wire harness or connector ·
Power switch ·
Certification ECU (smart key ECU assembly) |
With the shift lever in P, the key held near the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the key battery is depleted. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started when key battery is depleted by holding key near power switch and pressing and holding power switch with shift lever in P | - |
| DTC Code | Data List and Active Test |
|---|---|
| B278A | - |
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Reconnect the L197 certification ECU (smart key ECU assembly) connectors.
Reconnect the L194 power switch connector.
Using an oscilloscope, check the waveform.
Perform this inspection on the power switch side.
| Item | Content |
|---|---|
| Tester Connection | L194-10 (VC5) - L194-6 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition | Power switch off, key not in cabin, within 30 seconds after power switch pressed |
Waveform is output normally (refer to illustration).
| *a | Component with harness connected
(Power Switch) |
OK
NG
Disconnect the L197 certification ECU (smart key ECU assembly) connectors.
Disconnect the L194 power switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L197-1 (VC5) - L194-10 (VC5) | Always | Below 1 Ω |
| L197-24 (AGND) - L194-6 (AGND) | Always | Below 1 Ω |
| L194-10 (VC5) or L194-6 (AGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the L197 certification ECU (smart key ECU assembly) connector.
Reconnect the L194 power switch connector.
Measure the voltage according to the value(s) in the table below.
| *a | Component with harness connected
(Certification ECU (Smart Key ECU Assembly)) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L197-1 (VC5) - L197-24 (AGND) | Power switch off, brake pedal not depressed, 30 seconds or more after driver door opened and then closed | Below 1 V |
OK
NG